The induction time can be changed by adjusting the cam angle and the relative angle of the cam group. The basic components are made up of the cam pulse dial, the dial, the angle adjusting disc, and the electronic access to the hand wheel. There are 11 gears in the process of rotation, and the middle is the position. It can turn 5 gears to the left and right.

With good compatibility, the automation of a single precision punch and the free combination of multiple precision punch lines can be realized only by connecting signals. High stability, stable performance of stamping manipulator, low failure rate, easy maintenance.

Every day before work, you need to add lubricating oil to the press and scrub the machine tool to keep it clean. After cleaning the stock liquid system of the press, it needs to be debugged item by item. The press must be kept clean, and the air inlet net cover of the motor should always be kept in good ventilation condition, and should not be blocked. Check the handle knob button regularly for damage. Pay attention to whether the temperature and sound of the operating parts of the press are normal at any time.

The edge wall is the side wall of the edge of the punching die hole. The inclination of the cutting edge is the lower half of the whole die on each side of the hole wall of the blanking die, that is, the die part installed on the working table of the press. The lower die base is the bottom of the lower die, and the upper die is the upper part of the whole die, that is, the die part installed on the slider of the press.