In case of abnormal work, stop working immediately and check in time. It is forbidden to cut two layers of sheet at the same time; When the performance of the press is not familiar, it is not allowed to adjust the press without authorization; The manual lubricating oil pump shall be used to press lubricating oil to the lubricating point regularly; During the work, make the press perform several empty strokes, and check the working conditions of the brake, clutch and control part.

For small parts and small surplus materials, use compressed air to blow out the mold space, and for large parts, use manipulator to take out. In order to facilitate the discharge of parts, the high-speed precision punch mostly adopts the lower drive, the upper die is below, the punch and V-shaped blank holder are on the upper worktable, and the feeding axis is close to the blank holder. This arrangement can avoid the punched parts and surplus materials stuck in the punched belt hole. Discharge of two pieces and surplus materials.

Warning signs must be set up before the maintenance of punch press, and inform colleagues. In case of any abnormal operation during the operation of the press, press the emergency stop button immediately. Punch maintenance, if the operator is unclear, you can directly ask our maintenance personnel, we will give a detailed answer.

It means that open punch often occurs several fault reasons, in the future use must pay more attention to these reasons, and do a good job in prevention, to avoid these faults, effectively improve work efficiency, prolong service life. The air filter element of the press is blocked.